GLIDE Marine Seal System (GMSS) Kit

• GMSS Seal System assembly with Hump Hose and Clamps.

• Stainless Steel T-Fitting (**1-1/4” hose to 3/8” supply hose)

• Water Supply Hose / Clamps (4)

• Install Tool

GLIDE  Bearings and Seal Systems (MSSB LLC) warrants its marine products to be free from defects in material and workmanship under normal use and service when installed and used in its designed marine application.

This warranty shall be for the term up to four years from the date of the initial sale when used in a non-commercial marine application.

This warranty does not apply to any products that have been damaged for any reason after leaving the control of

GLIDE (MSSB LLC), including but not limited to damage caused by misuse, abuse, modification, negligence, accident, installation, excessive temperature or severe motoring conditions (excessive overloading resulting in hull flex/twisting), alteration or repaired in any form. During this warranty term, if an item is found to be defective in material or workmanship, it will be replaced or repaired at no charge, when returned with product label in-tact and prior GLIDE Marine Products (RMA) approval. Damage incurred during removal or return shipping is not covered by the return warranty. Proof of purchase must accompany the return.

GLIDE (MSSB LLC), in no event, will be held liable to buyer or to any other persons or party for incidental, consequential, special or indirect damages, lost profits or losses of buyer or any other party relating to GLIDE  (MSSB LLC),.

Some states do not allow limitations on how long implied warranty lasts or do not allow exclusion or limitation of incidental or consequential damages. The above limitations may not apply to you.

***PLEASE NOTE*** ALL GLIDE SHAFT SEALS MUST BE INSTALLED WITH THE PROVIDED INSTALL TOOL IN ORDER TO BE COVERED UNDER OUR 5-YEAR WARRANTY.

GLIDE has the ability to design and manufacture custom-size parts upon request! Seal Systems, Bearings and Rudder sleeves are available for ¾” through 4.0” Whether you're looking for one part or 1,000 pieces, we welcome all inquiries. Please contact us by calling (616) 868-9730 or emailing tim@glidebearings.com.

Give us a call at (616) 868-9730... Customer support and satisfaction is our #1 priority. Also, check out our YouTube channel for tips and instructions.

Since 2005, big-name boat brands have exclusively used GLIDE Bearings & Seal Systems. Below are just a few of them...

• MasterCraft

• NXT  

• Malibu

• Axis

• Centurion

• Supreme

• Correct Craft

• Nautique

• Tigé

• MB Sports

• Veratti

• Canadian Electric Boats

• Vandam Custom Boats

• Extends Shaft Life: Reduces wear on metal shafts

• High Load Capacity: GLIDE design load 4200 psi. Compressive yield strength 12700 psi.

• Frictional Properties: With its excellent frictional properties due to internal lubrication, this allowing higher speeds and loading in the most demanding conditions.

• Temperature Limits: With a working temperature of up to 245+F. With heavier loads, the maximum working temperature should be reduced for best performance.

• Serviceability: GLIDE-100 can be press fit, slip-fit, mechanically secured or epoxied. Electrolytic corrosion is not possible thus allowing for easily serviced bushings and no damage to the housing.

• Machinable: Glide-100 has no stress relief when machined and can hold tight tolerances.

• Food: Mixers, pumps, cart bushings, pallet jack wheel bearing, pivot bushings, meets FDA guidelines.

• Self-lubricating: Homogenous compound has 100% lubrication throughout.

Watch this short video to learn how to install your GMSS... It's easy!